Accessing the CLI#
- Open an SSH client, such as
PuTTY or OpenSSH.
- Enter the host name or IP address of the array. If you are asked to accept the authorization key, type yes.
- Log into the array with the username and the password you created when configuring the array.
The connection is made and you can now run the array CLI commands. For example, typing
array --list displays the name, serial, model, version, and status of the array:
$ array --list
c20-array2 AA-102081 CS220 3.1.988.0-354313-opt reachable
$ array --info c20-array2
Model: CS220
Extended Model: CS220-4G-12T-320F
Serial: AA-102081
Version: 3.1.988.0-354313-opt
All-Flash: No
Array name: c20-array2
Supported configuration: Yes
Link-local IP address: 169.254.54.168
Group ID: 3815276604473015474
Member GID: 1
Group Management IP: 10.18.120.51
1G/SFP NIC: 4/0
Total array capacity (MiB): 7606708
Total array usage (MiB): 0
Total array cache capacity (MiB): 305276
Volume usage (MiB): 0
Volume compression: 1.00X
Volume space saved (MiB): 0
Snapshot usage (MiB): 0
Snapshot compression: 1.00X
Snapshot space reduction: 1.00X
Snapshot space saved (MiB): 0
Pending Deletes (MiB): 0
Available space (MiB): 7606708
Member of pool: default
Status: reachable
Nimble OS $ ?
? folder pool timezone
alert group prottmpl useradmin
array halt reboot userauth
auditlog help route usersession
cert initiatorgrp setup vcenter
chapuser ip shelf version
ctrlr migration snap vm
date netconfig snapcoll vmwplugin
disk nic software vol
encryptkey partner sshkey volcoll
failover pe stats
fc perfpolicy subnet